Get Started Kit
Tiny Trainer – Laser-cut Foam Airframe
Firewall
Push Rods
Control Horns
Popsicle Sticks
Throw Gauge
BarBQ Skewers
Velcro
Rubber Bands
Specification Sheet
Specifications of Laser-cut Foam Airframe
Material: 5mm Single Side Brown Paper Laminated Foam Board
Weight: 10 Oz (Fully assembled; without battery)
Wingspan: 38 Inches (956mm)
Center of Gravity: 1.75 Inches (45mm) from the leading edge of the wing (Recommended)
Control Surface Throws: 12-16 Degrees
Expo Suggestions: 30%
+ Power Pack – Mini
1 x RS2205 2300KV Brushless DC Motor for QAV250 QAV300 Racing Drone
1 x Mounting Screw set
1 x Simonk 30A BLDC ESC Electronic Speed Controller
2 x Counter-Clockwise(CCW) HD Propellers 6045(6X4.5)
2 x Clockwise(CW) HD Propellers 6045(6X4.5)
4 x TowerPro SG90 9g Servo Motor with Cable
2 x Set of Horns
2 x Set of Screws
1 x Orange 11.1V / 1000mAh 3S 40C/80C Lithium polymer battery Pack (LiPo)
+ FlySky FS-i6 2.4G 6CH PPM RC Transmitter With FS-iA6B Receiver
Bandwidth (KHz): 500.
RF Range (GHz): 2.40 ~ 2.48.
No. of channels: 6.
Remote controller weight (gm): 400.
Power: 6V (1.5V AA*4).
Antenna Length: 26mm * 2 (dual antenna).
Transmitting Power: ≤ 20dBm.
RF Receiver Sensitivity: -105dbm.
+ LiPo Battery Voltage Checker 1S-8S with Buzzer
+ IMAX B3 AC Compact Balance Charger for 2S-3S LiPo
+ 40W Hot Glue Gun with 10 Glue Sticks
+ Safety Cutter
Reviews
There are no reviews yet.